Product guide
SRT TEST Signal
Send a generated moving test signal to verify an SRT receiver and network path.
Overview
Use this guide to check an SRT receiver or network path without preparing a camera feed.
Installation
- Install the application from its verified distribution link below.
- Prepare the receiving address, UDP port, SRT mode, and any encryption values.
- Keep the receiver status visible while starting the test.
Basic configuration
- Match the sending mode with the receiver's Caller or Listener mode.
- Enter the receiver address and
UDPport where required. - Configure matching encryption values when the path is encrypted.
- Select and start the generated test source.
Main operations
Watch the moving pattern at the receiver to distinguish a live signal from a frozen frame. Record the configured mode and port with the result so the test can be repeated.
Checks before use
- Confirm that the receiving application supports the transmitted stream.
- Check firewall and address translation rules on the UDP path.
- Treat a successful test as a path check, not proof that every production source is configured correctly.
Troubleshooting
If the receiver remains idle, check mode, address, port, and encryption in that order. See the common connection FAQ.